Building
This will build the default output for your Asus Zenfone 2 Laser/Selfie (1080p).
$ nix-build --argstr device asus-z00t -A build.default
Installation
The device will need to be booted in its bootloader, or fastboot, mode.
The boot image can be installed using the following command, assuming it was
built using the previous command.
$ result/flash-critical.sh
If you have a system image (system.img) built, you can use fastboot to
flash it to the device. Note that it might be too big to fit over the system
partition. In such case, it can be flashed on the userdata partition.
|
Warning
|
This will erase everything on the partition. Additionally, the
common backups methods, e.g. TWRP, will not backup the userdata partition.
|
$ fastboot flash userdata system.img
(No device-specific notes available)